How do I safely check and confirm a swap using a phone browser

07 September 2026

You open the swap site in your phone browser, complete the transaction on your mobile wallet, and then return to the browser to verify. The confirmation step is where errors that cost you money occur, so you must check three specific things before you consider the swap finished.

The phone browser is a smaller screen with more distractions. You are likely standing in line or sitting on a bus. That context makes it easy to misread a confirmation page, or to trust a page that is actually a phishing clone. The safety check requires deliberate action, not passive acceptance.

First, confirm the deposit was received. After your wallet broadcasts the transaction, the swap site should show a "Deposit detected" or "Received" status. Do not close the browser until this appears. If the site still says "Awaiting deposit" after five minutes, do not send again. Check the transaction on a block explorer instead. Copy the transaction ID from your wallet, paste it into a block explorer, and verify that the recipient address matches the one you saw on the swap site. If the address is wrong, the funds are lost.

Second, check the swap rate and the output amount before you confirm the swap. Many mobile swap sites show an estimated rate when you start, but the actual rate when the deposit arrives can differ. The site should display a firm rate and a firm output amount before you click "Confirm swap" or "Exchange". Read these numbers carefully. A common trick is that the site shows a good rate but then the final output is lower because of a hidden fee or slippage. If the output amount is less than you expect, cancel the swap and start over.

Third, confirm the withdrawal address one final time. The swap site will send the swapped tokens to a destination you entered earlier. On the confirmation page, that address should be displayed again. Read it character by character. On a phone, you can take a screenshot and zoom in, or read it aloud to yourself. Do not rely on the first few and last few characters matching. Clipboard malware on phones can replace copied addresses, but it cannot alter what you see on the screen if you read the whole thing.

The confirmation page itself might be a phishing site. If you reached the swap site through a link in a Telegram group or a sponsored ad, check the URL bar before you click anything. The real site's domain should match exactly. Phishers register domains like mad-pepe.vip or mad-pepe.com to catch people who mistype. Bookmark the correct URL beforehand so you are not typing it from memory.

After you confirm the swap, the site will show a "Completed" or "Sent" status. Wait for this. Do not navigate away until it appears. If your phone browser crashes or the site times out, the swap may still finish on the server side. In that case, check your wallet balance after ten minutes rather than restarting the swap immediately. Restarting a swap that already completed can send duplicate funds and the site may not refund the extra.

The same principles apply whether you are swapping on a desktop or a phone, but the phone's smaller screen and the risk of accidental taps make errors more likely. For a fuller explanation of these specific risks, see the hub page "Mobile wallet swap safety mistakes to avoid". That page covers the common failure points that this check procedure is designed to catch.

To summarize: verify the deposit arrived, read the final rate and output, and read the full withdrawal address. Do these three checks in order. If any of them look wrong, stop and start over. A swap that takes an extra two minutes is cheaper than a swap that sends your tokens to the wrong address.

Back to trezor